Intrigue V6-3.8L VIN K (1998)
NOTICE: Do not scrape, shim, or file bearing inserts. If the bearing surface of the insert is touched with bare fingers, the skin oil and acids will
etch the bearing surface.
IMPORTANT: Ensure that the connecting rod cap bolt holes and the connecting rod cap mating surfaces are clean and dry.
2. Use clean engine oil in order to lubricate the bearing surface.
3. Install the upper connecting rod bearing.
4. Use the J 41507, in order to pull down the piston, connecting rod and upper connecting rod bearing.
5. Remove the J 41507
6. Install the lower connecting rod bearing to the connecting rod cap.
7. Install the connecting rod cap.
8. Install the connecting rod cap bolts.
^
Tighten the connecting rod cap bolts to 27 Nm (20 ft. lbs.). Use the J 36660 in order to rotate the connecting rod cap bolts an additional 50
degrees.
NOTICE: Refer to Fastener Notice in Service Precautions.
9. Pry the connecting rod back and forth in order to check for binding. If necessary, loosen and then retighten the connecting rod cap bolts.