Intrigue V6-3.8L VIN K (1998)
9. Disconnect the forward lamp wiring harness.
10. Position all harnesses away from the junction block bracket.
11. Release the positive battery cable from the junction block bracket retainers.
Junction Block Replacement: Accessory Wiring - Removal Procedure
12. Remove the accessory wiring junction block nut.
13. Lift the junction block bracket up and out from the tab on the shock tower if necessary.
INSTALLATION PROCEDURE
Junction Block Replacement: Accessory Wiring - Installation Procedure
1. Insert the lower tab of the bracket into the shock tower slot, if necessary.
2. Insert the top of the bracket over the stud on the shock tower.
3. Install the accessory wiring junction block nut.
Tighten
Tighten the accessory wiring junction block nut to 3 N.m (27 lb in).
4. Position the positive battery cable to the junction block bracket and secure using the retainers.