Intrigue V6-3.8L VIN K (1998)
5. Select the proper clip to secure the splice. Follow the instructions in the J 38125-B Terminal Repair Kit in order to determine the proper clip size
crimp tool and anvil.
6. Overlap the two stripped wire ends and hold them between thumb and forefinger.
Splicing Copper Wire Using Splice Clips
7. Center the splice clip (2) over the stripped wires (1) and hold the clip in place.
^
Ensure that the wires extend beyond the clip in each direction.
^
Ensure that no insulation is caught under the clip.
Splicing Copper Wire Using Splice Clips
8. Center the crimp tool over the splice clip and wires.
9. Apply steady pressure until the crimp tool closes. Ensure that no strands of wire are cut.
Splicing Copper Wire Using Splice Clips
10. Crimp the splice on each end (2).