Intrigue V6-3.8L VIN K (1998)
Fuel Line Coupler: Service and Repair
Quick Connect Fitting(S) Service (Metal Collar)
Removal Procedure
Tools Required
J 37088 Tool Set, Fuel Line Quick-Connect Separator
WARNING: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
WARNING: Relieve the fuel system pressure before servicing fuel system components in order to reduce the risk of fire and personal injury.
After relieving the system pressure, a small amount of fuel may be released when servicing the fuel lines or connections. In order to reduce the chance of
personal injury, cover the regulator and the fuel line fittings with a shop towel before disconnecting. This will catch any fuel that may leak out. Place the
towel in an approved container when the disconnection is complete.
Notice: Before attempting any On-Vehicle Service, place a dry chemical (Class B) fire extinguisher near work area.
Notice: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes
and passages.
Important: Always maintain cleanliness when servicing fuel system components.
1. Relieve the fuel system pressure. Refer to Fuel Pressure Release Procedure.
2. Grasp both sides of the fitting. Twist the female connector 1/4 turn in each direction to loosen any dirt within the fitting.
3. Blow dirt out of the fitting using compressed air.
4. Choose the correct tool from J 37088 Tool Set for the size of the fitting. Insert the tool into the female connector, then push inward to release the
locking tabs.