Intrigue V6-3.8L VIN K (1998)
Shift Cable: Service and Repair
A/T Range Selector Cable Lever Replacement
REMOVAL PROCEDURE
1. Remove the throttle body air inlet duct.
2. Use a large flat-bladed tool in order to remove the automatic transaxle range selector lever cable from the automatic transaxle range selector lever.
3. Remove the automatic transaxle range selector lever nut.
4. Remove the automatic transaxle range selector lever.
INSTALLATION PROCEDURE
1. Install the automatic transaxle range selector lever.
2. Install the automatic transaxle range selector lever nut.
^
Tighten the automatic transaxle range selector lever nut to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.