Intrigue V6-3.8L VIN K (1998)
14. Slide large diameter of the halfshaft outboard boot (1) with the large boot retaining clamp (2) in place over the outside of the CV joint outer race
(3) and locate the boot lip in the groove on the CV joint outer race.
IMPORTANT: The halfshaft outboard boot (1) must not be dimpled, stretched or out of shape in any way. If the halfshaft outboard boot (1) is
not shaped correctly, equalize the pressure in the halfshaft outboard boot (1) and shape the boot properly by hand.
15. Crimp the boot retaining clamp (3) using J 35910.
^
Tighten Crimp the clamp (3) to 174 Nm (130 ft. lbs.).