Ninety-Eight V6-3.8L VIN K (1995)
SERVICE PROCEDURE
Remove or Disconnect
1.
Accessory Drive Belt Tensioner Bracket. Refer to Section 6A8-13.
2.
Heater coolant bypass inlet pipe assembly from tensioner bracket.
3.
Two O-rings from pipe assembly. Discard old O-rings.
Install or Connect
1. Dip new O-rings in clean engine coolant to aid in installation.
2. New service purple O-ring to end of pipe that attaches to the lower intake manifold.
3. New production orange O-ring to end of pipe that attaches to tensioner bracket.
4. Heater coolant bypass inlet pipe assembly to tensioner bracket.
5. Accessory Drive Belt Tensioner Bracket. Refer to Section 6A8-13.
PARTS INFORMATION
Description
Color
Part Number
Service Seal
Purple
24505540
Production Seal
Orange/Black
25537068
Parts are currently available from GMSP0.
WARRANTY INFORMATION
Labor
Operation
Description
Labor Time
J0680
R&R Tensioner
Use published labor
Serpentine Belt
operation time.