Ninety-Eight V6-3800 3.8L (1989)
1. Trim panel and water deflector.
2. Regulator to door inner panel rivets (4) using a 6.3 mm (1/4") drill bit. Punch out rivet centers, then perform drilling operation.
3. Regulator guide ana block assembly from lower sash channel by positioning window half way down3 and pushing regulator forward. Once
removed, tape glass in full up position.
4. Wire connector (3).
5. Regulator through access hole.
INSTALL OR CONNECT
1. Position regulator to door through access hole.
2. Guide and block assembly to regulator.
3. Wire connector (3)
4. Regulator to door using 6.3 mm (1/4") peel type rivets (4).
5. Check window operation.
6. Water deflector and trim panel.
Manual Window
WINDOW REGULATOR
Regulator Removal
REMOVE OR DISCONNECT
1. Trim panel and water deflector.
2. Safety belt retractor..
3. Any items that may be clocking access hole as necessary.
4. Regulator-to-door inner panel rivets using a 6.3 mm (1/4") drill bit.
5. Block or tape window in fully up position.
6. Regulator guide and block assembly from lower sash by rotating regulator rearward 180 degrees.
7. Regulator through access hole.
INSTALL OR CONNECT
1. Position regulator to door through access hole.
2. Guide and block assembly to sash channel.
3. Regulator to door using 6.3 mm (1/4") peel-type rivets.
4. Tape and check for proper window operation.
5. Trim panel and water deflector.
6. Safety belt retractor.
Window Regulator - Rear Door
WINDOW REGULATOR