Ninety-Eight FWD V6-181 3.0L (1985)
The following procedure is required when replacing the Cherry "touchpad" power mirror control switch with the Micro Craft "joystick" power mirror
control switch using the Switch Service Kit.
1.
Remove the triangular mirror trim covering and foam sealer in the upper front corners of the front doors to obtain access to door harness mirror
connector.
2A.
1985 Ninety-Eight
Left Side *
Right Side *
1.
Cut the light blue wire
1.
Swap the light blue and
approximately 76 mm (3") back
yellow wires in the harness
from the connector. Tape
side of the connector.
back the end going to the harness.
2.
Splice the three inch end of
2.
Cut the yellow wire the
light blue wire into the
approximately 76 mm (3") back
light green/black wire.
from the connector. Tape
back the end going to the harness.
3.
Splice the 76 mm (3") end
on the yellow wire into
the light green wire.
*
See Figure 1 for reference.
IMPORTANT:
Do not use the right or left mirror motor jumper harnesses.
2B.
1986 through 1988 1/2 Delta 88; 1986 through 1988 1/2 Ninety-Eight
In order for the kit to work, there is one more thing to be done. The right door jumper harness must be changed. The right jumper has a three wire
end and a four wire end. On the end with three wires, the blue wire is to be moved to the empty cavity of the connector. The mirrors will work with
the corrected jumper installed.
Insert the right and left mirror motor jumper harnesses between the mirror motor pigtails and door harnesses. Be sure to use the correct part
number for each door.
3.
Fully seat mirror control switch into the escutcheon. Position the switch so the pigtail exits directly under the word "mirrors" on the escutcheon.
Secure the switch into the escutcheon using the set screw.