Ninety-Eight FWD V6-260 4.3L DSL (1985)
19.
Water test using a spray. Use warm water if available. Do not direct hard stream of water at uncured urethane. If any leaks are found, add extra
urethane at leak point.
NOTICE:
Water applied on top of urethane, either during water test or as a separate operation, will speed up cure of urethane.
20.
Install all remaining moldings.
21.
NOTICE: Vehicle must be kept at a minimum of 65~ F for 6 hours to allow material to cure.
22.
Remove taps (if used).
