Silhouette V6-191 3.1L (1990)
Dash Board / Instrument Panel: All Technical Service Bulletins
Instrument Panel Pad - Correct R & R Procedure
NUMBER:
90-T-187
CORP.REF.NO: 038303R
DATE:
December 1990
SECTION:
8C
SUBJECT:
SERVICE MANUAL UPDATE - INSTRUMENT PANEL
AND GAUGES
CORRECT REMOVAL/INSTALLATION PROCEDURE
MODELS/YEARS:
1990 SILHOUETTE
This procedure is the correct Removal and Installation of Instrument Panel (I/P) Trim Pad for the 1990 Silhouette. This procedure replaces the existing
procedure found on pages 8C-l 1 and Figure BC-19 of the 1990 Silhouette Service Manual.
I/P PAD ASSEMBLY
A.
REMOVE OR DISCONNECT
1.
Side window defroster vent grilles (2), to access retaining screws (2).
2.
I/P trim pad retaining screws (4) two at top of I/P cluster, two through glove compartment (View A).
3.
Lift I/P pad up and pull rearward to disengage retaining tabs at front of pad.
4.
I/P pad assembly from vehicle.
B.
INSTALL OR CONNECT
1 .
Position I/P pad to lower I/P pad, push to engage retaining tabs.
2.
I/P trim pad retaining screws (4) two at top of cluster, two through glove compartment (View A).
3.
Retaining screws at side window defroster outlets and grilles.