Silhouette V6-191 3.1L VIN D TBI (1995)
^
To install right-hand wiper arm assembly (14), measure from tip of blade assembly to bottom edge of glass. This must be 33 mm (approx.
1-1/4 in.).
3. Nut (11) on drive shaft finger-tight, then remove pin near arm pivot.
Important It may be necessary to allow for some movement of wiper arm assembly when nut (11) is being tightened. If arm assembly moves away from
desired alignment mark, loosen nut and reposition arm assembly by moving blade tip.
Tighten
^
Nut (11) to 53 N.m (39 lb. ft.) while holding blade tip.
4. New nut cover (10).
5. Washer hose(12).
Inspect
^
Run wipers and check for proper wipe pattern.
^
Shut off wipers and check for correct park position.
