Silhouette FWD V6-3.4L VIN E (2004)
6. Remove the nut (3) and bolts (1, 2) holding the accelerator cable bracket to the throttle body.
7. Remove the accelerator cable bracket.
INSTALLATION PROCEDURE
1. Position the accelerator cable bracket on the throttle body.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the nut (3) and bolts (1, 2).
Tighten
-
Tighten the bolts in sequence (2, 1) to 13 N.m (115 lb in).
-
Tighten the nut in sequence (3) to 10 N.m (89 lb in).
1. Install the wire harness into the retainer.
2. Install the air intake duct.