Silhouette FWD V6-3.4L VIN E (2004)
5. Note the routing of the inflator module wiring harness (2) and the retaining clip attachments within the passenger seat.
6. Remove the wiring harness retaining clips from the passenger seat frame.
7. Remove the wiring harness (2) from the passenger seat frame.
8. Remove the air bag inflator module (1) from the passenger seat back frame.
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Install the inflator module wiring harness (2) to the passenger seat frame, while guiding the wiring harness through the appropriate spots on the
passenger seat frame.
2. Install the wiring harness retaining clips to the passenger seat frame.