Silhouette FWD V6-3.4L VIN E (2004)
Stabilizer Link: Service and Repair
Front Suspension
The content of this article reflects the changes identified in TSB Bulletin No. #05-03-08-013 dated September 02, 2005
.
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise the vehicle and suitably support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the stabilizer shaft link bolt and nut.
4. Remove the stabilizer shaft link from the vehicle.
Installation Procedure
1. Install the stabilizer link into the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the stabilizer shaft link bolt and nut.
^
Tighten the stabilizer shaft link nut to
19 Nm (14 lb ft).
3. Install the tire and wheel assembly.
4. Lower the vehicle.