Silhouette FWD V6-3.4L VIN E (2004)
Case: All Technical Service Bulletins
A/T - Case Side Cover Replacement Revision
Revised Case Side Cover Replacement Procedure # 04-07-30-038B - (Feb 16, 2005)
Models:
2005 Buick Terraza
2002-2005 Chevrolet Venture
2005 Chevrolet Uplander
2002-2004 Oldsmobile Silhouette
2002-2005 Pontiac Montana
2005 Pontiac Montana SV6
2005 Saturn Relay
without All-Wheel Drive (AWD)
This bulletin is being revised to add a step for installing the engine support fixture. Please discard Corporate Bulletin Number 04-07-30-038A (Section
07 - Transmission/Transaxle).
This bulletin is being issued to revise the Case Side Cover Replacement procedure in the Automatic Transmission sub-section of the Service Manual.
Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.
Case Side Cover Replacement
Removal Procedure
1.
Remove the throttle body air inlet duct. Refer to Air Cleaner Element in Engine Controls.
2.
Remove the engine mount struts.
3.
Remove the wiper cover.
4.
Disconnect the 20-way electrical connector at the transmission.
5.
Remove the shift cable bracket from the transmission.
6.
Install the engine support fixture and support the engine/transaxle assembly. Refer to Engine Support Fixture in Engine Mechanical.
7.
Raise and support the vehicle.
8.
Remove the left front tire and wheel.
9.
Remove the left wheel speed sensor harness connector (1).
10.
Remove the left engine splash shield.
11.
Remove both stabilizer shaft links from the lower control arms.
