Toronado V6-231 3.8L (1986)
Brake Caliper: Service and Repair
Delco-Moraine Single Piston W/Dual Bolt Mounting (Type 4)
Front
Fig. 1 Delco-Moraine series 3264M front disc brake caliper exploded view.
1.
Drain approximately 2/3 of brake fluid from master cylinder assembly.
2.
Raise and support vehicle, then mark position of wheel and remove tire and wheel assembly.
3.
If caliper is to be serviced or replaced, remove bolt securing inlet fitting, then disconnect brake hose and secure in raised position. If only shoe
and lining assemblies are being replaced, do not disconnect brake hose from caliper.
4.
Remove caliper to support mounting bolts, then lift caliper off support. If only shoe and lining assemblies are to be replaced, suspend caliper from
chassis using suitable hanger. Do not allow caliper to hang by brake hose.
5.
Remove insulators (4) from caliper support if equipped, Fig. 1.
Rear