Toronado V6-231 3.8L (1986)
The torque on the union at the pump should be checked for 75 N-m (55 Lbs.Ft.) if this method is used. To torque the union, the power
steering pump pulley must first be backed off about 19 mm (3/4 inch) with tool J 25034-B to allow socket access to the union hex.
Reposition the pulley using tool J 25033-B.
4.
Reverse Steps (2) and (3) to install new power steering pressure hose assembly, Part Number 26013680. See illustration for torques and routing
information. Connect negative battery cable.
5.
Fill and bleed power steering system, following procedure outlined below:
A.
Raise the front of vehicle until the front wheels are off the ground.
B.
Make sure power steering reservoir is filled with power steering fluid to the proper level and maintain level during Steps (C) and (D).
C.
With engine turned off (not running), slowly turn the steering wheel from lock to lock.
D.
Have an observer watch the fluid in the reservoir as the steering wheel is being turned. Continue turning steering wheel until air bubbles are
no longer seen rising from the fluid.
6.
Check system for leaks and proper operation.
7.
Install a Campaign Identification Label.
8.
Remove fender cover and close hood.
CAMPAIGN IDENTIFICATION LABEL
Each label provides space to print the campaign number and the five (5) digit dealer code of the dealer performing the campaign. Insert this information
with a typewriter or ballpoint pen. When installing label, clean and dry the surface of the radiator support tie bar and apply the campaign label where it is
readily visible.
PARTS INFORMATION
To ensure parts are obtained is soon as possible, order them from GM Service Parts Operations (GMSPO) on a CIO order, with NO special instruction cod
Description
Part Number
Quantity Per Vehicle
Power Steering Pressure Hose Assembly
26013680
1
(GMSPO Name:
Hose, P.S. Gear Inlet)
WARRANTY CLAIM INFORMATION
PC
PART-NO
TOT-PTS
TC
LAB-OP
LHRS
ST
SUBLET
Replace power steering pump pressure hose assembly.
96
V4690
.8*
- - -
- - -
*
.1 hour for clerical administration may be added to the above operation.
Parts Allowance:
Current dealer price, plus 30% handling allowance.
An allowance for power steering fluid may be applied for in the normal manner; list two (2) "parts" in the "TOT-PTS" column.