peugeot Workshop Repair Guides

Peugeot Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 2
background image

complaining of speedometer accuracy problems (Service Bulletin No. 369)

-

Install cable end into CC speedsensor housing; it may be necessary to rotate the driven gear, slightly for easier engagement with cable; DO
NOT FORCE PIECES TOGETHER

-

Install assembly into transmission housing, being careful not to separate any of the parts

-

Install rubber locking pin and CC speedsensor housing 11 mm hold-down bolt

-

Route the adapter wiring harness along side the firewall and up to the speedometer cable grommet in the firewall; continue to route the
harness along side the speedometer cable and connect to CC speedsensor

-

Tie-strap the adapter wiring harness to the speedometer cable:

1)

3" from the CC speedsensor

2)

midway between CC speedsensor and speedometer cable firewall grommet

3)

at speedometer cable firewall grommet

-

Reattach speedometer cable to heater hose clip on "S" models and to bracket on engine block on all models

WARRANTY INFORMATION:

This repair will be accepted when performed within the New Vehicle Limited Warranty period of three (3) years and/or 36,000 miles, whichever occurs
first.

Damage Code:

616014

Operation Number:

991225

Time Allowance:

0110 hours

Powertrain Management > Transmission Control Systems > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - A/T > Transmission Speed Sensor, A/T > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Transmission Speed Sensor: > 382900501 > May > 90 > Speedometer Cable - Clicking Noise and Needle Vibration > Page 2281

< PREV PAGE NEXT PAGE >