Acclaim V6-181 3.0L SOHC (1990)
a. Connect two wiring connectors to ignition switch. Ensure switch locking tabs are fully seated in connectors.
b. Install ignition switch on steering column.
c. On column shift models, shift lever must be in P position and park lock dowel pin on ignition switch assembly must engage with column park
lock slider linkage.
d. On all models, verify ignition switch is in Lock position (flag parallel with ignition switch terminals).
e. Apply a dab of suitable grease to flag and pin, then position park lock link and slider to mid-travel.
f.
Position ignition switch against lock housing face. Ensure pin is inserted into park link contour slot.
g. Install ignition switch retaining screws and torque to 12-22 lb-in.
h. With ignition lock and switch in Lock position, insert ignition lock into ignition switch until it bottoms.
i.
Insert key, then while carefully pushing ignition lock toward ignition switch, turn key clockwise to Run position.
j.
Check for proper operation on ignition switch in all positions.
