Colt L4-1597cc 1.6L DOHC (1990)
c. Spindle lever shaft and piston for rust.
d. Bearing for wear, piston seal and boot for wear, cracks or deterioration.
Fig. 4 Installation Direction Of Spring Washers On Spindle. AD Type Caliper
10.
Reverse procedure to assemble, noting the following:
a. Apply grease supplied in brake seal kit to lever boot, spindle lever, O-ring, connecting link and auto-adjuster spindle.
b. Compress spring case into caliper body using a 3/4 inch steel pipe as shown, then install snap ring using suitable snap ring pliers. Install snap
ring to caliper body with opening facing bleeder.
c. Apply grease supplied in brake seal kit to cylinder walls, piston seal and piston, then install piston seal into cylinder.
d. Using piston driver MB990652 or equivalent, press piston into caliper body with stopper grooves aligned.
e. Apply grease supplied in brake seal kit to piston boot mounting grooves in caliper body and piston, then install piston boot.
f.
Apply grease supplied in brake seal kit to guide pin boot inner surface, lock pin boot inner surface and lock pin sleeve.
g. Adjust parking brake cable.
