Gran Fury L6-225 3.7L VIN E 1-bbl (1982)
8. Remove gauge unit using a hammer and a nonmetallic drift. Slide gauge unit assembly out of fuel tank. Discard gasket.
9. Remove filler tube.
Installation
Before installing the fuel gauge, check the condition of the filter on the end of the suction tube. If the filter is plugged, install a new one.
1. Insert a new gasket in fuel gauge opening recess then slide gauge into tank. Align the positioning tangs on gauge with those in tank. Install
lockring, then tighten securely using a hammer and non metallic punch.
2. Using engine oil as a lubricant, install a new filler tube rubber grommet. Be sure that the inner sealing surface of the grommet is not folded.
3. Locate insulator pad on top of tank. (If tank insulator was torn or damaged during removal of tank, install new insulator).
4. Place tank under vehicle on transmission jack, raise tank to position.
5. Reconnect fuel supply line, ground wire, vent line and wire lead to gauge unit.
6. Carefully raise tank into position with jack and with retaining straps attached install bolts. Tighten bolts to 30 +/- 10 foot-pounds (41 +/- 14 Nm).
7. Lubricate filler tube grommet with engine oil and slide filler tube into tank. Install filler tube mounting screw and tighten.
8. Refill tank and inspect all lines and hoses for leaks.