Grand Fury/Salon V8-318 5.2L VIN P 2-bbl (1984)
12.
Lower the car and adjust the alignment on the side where the spacers were installed according to the procedures and specifications in the service
manual.
NOTE:
THE UPPER CONTROL ARM SPACERS ARE TO BE USED ONLY AS A SET (1 LONG AND 1 SHORT) ON THE
SIDE WHERE THEY ARE NEEDED. UNDER NO CIRCUMSTANCES ARE SPACERS TO BE STACKED TO
GAIN ADDITIONAL POSITIVE CAMBER ADJUSTMENT.
POLICY:
Reimbursable within the provisions of the warranty
TIME ALLOWANCE:
Labor Operation No.
02-10-55-90 . . . . . . . . .
1.8 Hrs.
Includes Shim One Side and Align Front End
02-10-55-91 . . . . . . . . .
2.5 Hrs.
Includes Shim Both Sides and Align Front End
FAILURE CODE:
50 - Improper Adjustment
Technical Service Bulletin # 020586
Date: 861222
Alignment - Insufficient Positive Camber Adjustment
Models
1983-1987 Gran Fury, Diplomat & 5th Avenue
Subject
Insufficient Positive Camber Adjustment
Index
FRONT SUSPENSION
Date
December 22, 1986
No.
02-05-86 REVISION A P-4482
This bulletin supersedes Technical Service Bulletin 02-05-86, which should be removed from your files. The rear spacer part number has been corrected
to PN 4014353, and labor operation numbers and time have been assigned.
SYMPTOM/CONDITION
Insufficient positive camber adjustment.
PARTS REQUIRED
1
Spacer, Front Suspension Upper
PN 4014352
Control Arm Pivot Support - Front
1
Spacer, Front Suspension Upper
PN 4014353
Control Arm Pivot Support - Rear
REPAIR PROCEDURE
This repair outlines the installation of upper control arm support plate spacers.
1.
Loosen the caster/camber adjusting nuts (not necessary to remove them).
2.
Raise car and remove wheel.
3.
Loosen shock absorber upper nut (not necessary to remove).