Grand Voyager L4-2.4L DOHC (1996)
CAUTION: Hub and bearing assembly mounting surfaces on the steering knuckle and halfshaft must be smooth and completely free of foreign
material or nicks prior to installing hub and bearing assembly.
CAUTION: When installing hub and bearing assembly into steering knuckle, be careful not to damage the bearing seal on the outer CV joint.
1. Install hub/bearing assembly onto stub axle and into steering knuckle until squarely seated on the face of the steering knuckle.
2. Install the 4 hub/bearing assembly to steering knuckle attaching bolts. Equally tighten all 4 mounting bolts in a criss-cross pattern until hub!
bearing assembly is squarely seated against front of steering knuckle. Then tighten the 4 hub and bearing assembly mounting bolts to a torque of
65 Nm (45 ft.lbs.)
3. Install the hub/bearing assembly to stub shaft washer and retaining nut. Tighten, but do not torque the hub nut at this time.
4. install the braking disk on the hub and bearing assembly.
