Grand Voyager V6-201 3.3L VIN R SMFI (1997)
Tone Wheel Removal From Hub/Bearing Assembly
7. Install wheel lug nuts on 3 of the wheel mounting studs to protect the stud threads from damage by the vise jaws. Mount the hub/bearing assembly
in a vise. Using Puller, Special Tool C-4693, or equivalent installed as shown above remove the tone wheel from the hub/bearing assembly.
Installing Tone Wheel On Hub/Bearing Assembly
INSTALLATION
1. Place hub/bearing assembly in an arbor press supported by Receiver, Special Tool, 6062A-3, or equivalent. Position Driver, Special Tool 6908-1,
or equivalent with undercut side facing up on top of the tone wheel.
Correctly Installed Tone Wheel
2. Press the tone wheel onto the hub/bearing assembly until it is flush with the end of hub shaft.
3. Install the 4 hub/bearing to axle flange mounting bolts into the 4 mounting holes in the flange of the rear axle.
4. Install the rear brake support plate on the 4 mounting bolts installed in the flange of the rear axle.
5. Align the rear hub/bearing assembly with the 4 mounting bolts and start mounting bolts into hub/bearing assembly. Tighten the 4 bolts in a
cries-cross pattern until the hub/bearing and brake support plate is fully and squarely seated onto flange of rear axle.