Grand Voyager V6-201 3.3L VIN R SMFI (1997)
Air Bag Control Module: Service and Repair
WARNING: The ACM contains the impact sensor which enables the system to deploy the airbags. To avoid accidental deployment,
never connect ACM electrically to the system while vehicle battery is connected. Disconnect and isolate the battery negative cable before
beginning any airbag system component service procedures. This will disable the airbag system. Failure to disconnect the battery could
result in accidental airbag deployment and possible personal injury. Allow system capacitor to discharge for two minutes before
removing airbag components.
REMOVAL
1. Disconnect and isolate battery negative cable. Allow at least two minutes for the reserve capacitor in the Airbag Control Module (ACM) to
discharge.
2. Remove forward lower console from instrument panel.
3. Remove screw holding lower heat duct to instrument panel support.
4. Remove heat duct from instrument panel.
5. Remove bolts holding top of right support to instrument panel.
6. Remove bolts holding bottom of right support to floor pan.
7. Separate right instrument panel support from vehicle.
