Grand Voyager V6-229 3.8L (1996)
Remove Battery
5. Remove battery from vehicle.
INSTALLATION
Inspect and clean battery and attaching components before installation.
1. Install battery in vehicle making sure that battery is properly positioned on battery tray.
2. Install battery hold down.
3. Place battery heat shield over battery. The top inside surface of heat shield must be flush with top of battery
4. Connect battery cable terminals, positive cable first. Make sure the top of battery terminals are flush with top of posts.
WARNING: DO NOT OVER TIGHTEN BATTERY CABLE CLAMPS, DAMAGE TO CLAMPS CAN RESULT.
5. Tighten terminal nuts to 8.5 N.m (75 in. lbs.).
NOTE: On some models you will need to perform the LED reset procedure after charging or replacing the battery. See: LEDs Flashing - A/C
Calibration/Diagnostics and Cooldown Test
Battery Tray Replacement
REMOVAL
1. Remove battery.
Battery Tray Removal
2. Remove nut and two bolts from battery tray.
3. Remove battery tray from vehicle.