Grand Voyager V6-3.0L VIN 3 (1998)
8. If hub/bearing cannot be removed from the axle by hand, use Remover Special Tool 8214 or equivalent and following procedure to press the
hub/bearing out of the axle.
a. Place Special Tool 8214-1 or equivalent over tone wheel and against cast flange of hub/bearing
b. Put a dab of grease in the bolt pilot hole on the back of Special Tool 8214-1 or equivalent.
c. Insert Special Tool 8214-2 or equivalent into the bole in the bottom of the end casting on the axle. Special Tool 8214-2 or equivalent should
be against and supported by the axle plate when pressing the wheel bearing out of the axle. If Special Tool 8214-2 or equivalent will not fit
into the hole in the end casting, file or grind the flashing from the hole until tool fits properly.
d. Align bolt in Special Tool 8214-2 or equivalent with pilot hole in Special Tool 8214-1 or equivalent. Tighten bolt against Special Tool 8214-1
or equivalent.
e. Press hub/bearing out of axle by continuing to tighten bolt in Special Tool 8214-2 against Special Tool 8214-1 or equivalents.
9. Remove the hub/bearing from the rear axle and brake support plate.
