Grand Voyager V6-3.0L VIN 3 (1998)
Engine Mount: Service and Repair
Rear Mount
1. Raise vehicle on hoist.
2. Support the transmission with a transmission jack so it will not rotate.
3. Remove the insulator through bolt from the mount and rear suspension crossmember.
4. Remove the four transmission mount fasteners and remove the mount.
Engine Mount-Rear
5. Reverse the removal procedure for installation.
ENGINE MOUNT RUBBER INSULATORS
Insulator location on (right side) is adjustable to allow right/left drive train adjustment in relation to driveshaft assembly length. See Engine Mount
Adjustments in this section.
Check and reposition right engine mount insulator. Adjust drive train position, if required, for the following conditions:
-
Driveshaft distress: See Suspension and Driveshafts.
-
Any front end structural damage (after repair).
-
Insulator replacement.