Grand Voyager V6-3.0L VIN 3 (1998)
Camshaft Oil Seal: Service and Repair
END SEAL(PLUG) - IN VEHICLE SERVICE
1. Remove air cleaner assembly from engine.
2. Use a small punch and a hammer, carefully remove cam plug from cylinder head.
3. Clean the area of the cylinder head where the new cam plug will be installed.
4. Apply a light coating of Mopar Silicone Rubber Adhesive Sealant to the outer diameter of the NEW cam plug.
5. Using a suitable installing tool and a hammer, install the new cam plug to a depth of 0.6 mm (0.020 inch) below the surface of the cylinder head.
6. Replace air cleaner assembly.
OIL SEAL (PLUG) OUT OF VEHICLE SERVICE
1. Apply light coat of engine oil to the camshaft oil seal lip.
2. Install the oil seal using camshaft oil seal installer tool MD-998713.
END SEAL (PLUG) SERVICE OUT OF VEHICLE SERVICE
Install end seal plug with Special Tool MD-998306, or equivalent.