Grand Voyager V6-3.0L VIN 3 (1998)
Door Sensor/Switch (For Alarm): Service and Repair
Sliding Door Ajar (VTSS Trigger) Switch
REMOVAL
1. Release the sliding door latch and allow back of the door to pop open.
Sliding Door Ajar Switch
2. Through opening at the rear edge of the sliding door on outside of the vehicle, pry door ajar switch from quarter panel opening.
3. Disconnect the wire connector from the back of the ajar switch.
4. Remove the sliding door ajar switch.
INSTALLATION
-
For Installation, reverse the above procedures.