Grand Voyager V6-3.0L VIN 3 (1998)
5. Using pliers expand tie rod boot, to inner tie rod clamp and remove from steering gear boot.
6. Remove inner tie rod boot to steering gear clamp.
NOTE: After removing inner boot clamps. Use a very small screwdriver to lift boot from its retaining groove in steering gear. Then the boot can
be removed from steering gear.
INSTALL
1. Install tie rod boot to steering gear clamp on tie rod boot.
2. Install tie rod boot and clamp on inner tie rod.
3. Install tie rod boot over steering gear housing and onto the end of the breather tube.
4. Crimp inner tie rod boot to steering gear clamp using Crimper, Special Tool C4975A, or equivalent. When installing clamp, Special Tool
C4975A, or equivalent must have bottom bolt tightened until their is no gap between the 2 bars of the tool.
5. Lubricate inner tie rod boot groove with silicone type lubricant, then install outer boot seal to inner tie rod clamp. (Clamp will have to be loosened
for toe adjustment).
6. Install inner to outer tie rod jam nut on inner tie rod.
7. Install outer tie rod on inner tie rod. Do not tighten jam nut.