Grand Voyager V6-3.0L VIN 3 (1998)
Tie Rod End Removal From Steering Knuckle
10. Remove the tie rod end stud from steering knuckle arm, using remover, Special Tool MB-991113.
Wheel Speed Sensor Cable Routing Bracket
11. If equipped with antilock brakes, remove the speed sensor cable routing bracket from the steering knuckle.
Lower Ball Joint To Steering Knuckle Attachment
12. Remove cotter pin and castle nut from stud of lower ball joint at the steering knuckle.
CAUTION: No tool is to be inserted between the steering knuckle and the lower ball joint to separate stud of lower ball joint from the steering
knuckle. The steering knuckle is to be separated from the stud of the ball joint only using the procedure as described in Step 13.