Grand Voyager V6-3.3L VIN G Flex Fuel (1999)
Garage Door Opener Transmitter: Service and Repair
Replacement
Universal Transmitter
REMOVAL
The Universal Transmitter is serviced with the transmitter bin door, in the overhead console.
Battery Negative Cable
1. Disconnect and isolate the battery negative cable.
2. Open transmitter bin door in rear of overhead console.
3. Gently pull towards rear of vehicle, releasing transmitter bin door.
4. Disconnect harness connector from Universal Transmitter and remove bin door from vehicle.
INSTALLATION
For installation, reverse the above procedures. The Universal Transmitter will need to be retrained. Refer to SERVICE PROCEDURES.
Message Center
REMOVAL
Battery Negative Cable
1. Disconnect and isolate the battery negative cable.
2. Remove A-pillar trim panel.
3. Remove instrument panel top cover. Refer to Instrument Panel Top Cover Replacement.
4. Disconnect the wire connector from back of message center
5. Remove screws holding message center to instrument panel top cover.