Grand Voyager V6-3.8L VIN L (1999)
6. Remove message center from instrument panel top cover.
INSTALLATION
1. Place message center in position on top cover.
2. Install screws to hold message center to instrument panel top cover.
3. Connect wire connector into back of message center.
4. Install instrument panel top cover.
5. Install A-pillar trim.
Message Center Lamp
REMOVAL
Battery Negative Cable
1. Disconnect and isolate the battery negative cable.
2. Remove instrument panel top cover. Refer to Instrument Panel Top Cover Replacement.
Message Center Lamp Location
3. Locate the lamp in question.
4. Remove lamp and check lamp. If lamp is good test the power supply to the lamp.
INSTALLATION
For installation, reverse the above procedures.