Grand Voyager V6-3.8L VIN L (1999)
Wheel Fastener: Service and Repair
Front
REMOVAL
CAUTION: If a wheel attaching stud needs to be replaced in the hub and bearing assembly the studs CANNOT be hammered out of the hub flange.
If a stud is removed by hammering it out of the bearing flange, damage to the hub and bearing assembly will occur leading to premature bearing
failure.
The following procedure and special tools shown MUST BE used when replacing wheel attaching studs. The hub and bearing assembly does not
require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing assembly.
1. Raise vehicle on jackstands or centered on a frame contact type hoist.
2. Remove the front wheel and tire assembly from the vehicle.
Disc Brake Caliper Mounting
3. Remove the front caliper assembly from the front steering knuckle assembly.
4. Remove front rotor from hub, by pulling it straight off wheel mounting studs.
5. Install a lug nut on the wheel stud to be removed from the hub and bearing assembly, so the threads on the stud are even with end of lug nut.
