Neon L4-2.0L SOHC (1995)
Key Cylinder Lamp: All Technical Service Bulletins
Ignition Key Lamp - Lack of Illumination
NO: 08-49-94
GROUP: Electrical
DATE: Sep. 16, 1994
SUBJECT:
Ignition Key Lamp Illumination
MODELS:
1995 (PL) Neon
NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH SALES CODE ADA (LIGHT GROUP), WHICH INCLUDES AN
ILLUMINATED IGNITION KEY SWITCH WITH TIME DELAY.
SYMPTOM/CONDITION:
Lack of illumination of ignition key switch.
PARTS REQUIRED:
1
4796657
Clip, With Shim
REPAIR PROCEDURE:
This bulletin involves increasing the clearance between the instrument panel and the steering column cover to allow more light to focus on the ignition
key switch.
1.
Remove the instrument panel top cover and cluster bezel and the right trim panel as outlined in the 1995 Neon Service Manual (Publication No.
81-270-5025), Page 8E-7. Disconnect the wiring connector to the rear window defogger and fog lamp switch located on the right trim panel, if
vehicle is so equipped.
2.
Remove 2 mm (approximately 1/16 in.) of material from the upper portion of the left instrument panel clip attachment hole (refer to illustration).
3.
Remove the old clip on the right trim panel and install new clip P/N 4796657, on the trim panel with the clip portion facing upward. The new clip
has additional material on the bottom surface that will force the panel upward when it is installed on the instrument panel. This will allow a
minimum of 3 mm (approximately 1/8 in.) clearance between the right trim panel and steering column cover (refer to illustration).
4.
Connect the wiring connector to the rear window defogger and fog lamp switch located on the right trim panel, if disconnected in Step 1. Replace