Neon L4-2.0L SOHC (1995)
Supplemental Restraint System (SRS) Control Module: Service and Repair
WARNING: The ACM contains a safing sensor which enables the system to deploy the airbags. To avoid accidental deployment, never connect
ACM electrically to the system while vehicle battery is connected. Disconnect and isolate the battery negative (ground) cable before beginning
any airbag system component removal or installation procedure. This will disable the airbag system. Failure to disconnect battery could result
in accidental airbag deployment and possible personal injury. Allow system capacitor to discharge for 2 minutes before removing any airbag
components.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Automatic transaxle only, remove shifter knob fastener and remove shifter knob.
3. Remove attaching screw from each of the two forward cup holders of the floor console. Remove screws at the rear of the console or with armrest
inside of console bin.
4. Pull park brake lever all the way up.
Fig. 12 Airbag Control Module
5. Lift the floor console at the rear and guide it out from under the instrument panel.
6. Remove module mounting nuts and remove module.
Fig. 13 Airbag Control Module
7. Disconnect ACM 4-way and 13-way connectors.
INSTALLATION
1. Connect ACM both connectors and ensure both connectors and all locking tabs are engaged.
CAUTION: Use supplied screws only.
2. Position ACM (arrow pointing forward) in the console floor bracket, attach the nuts and tighten to 11 to 14 Nm (105 to 125 in lb) torque.
