Neon L4-2.0L VIN C (1997)
Rocker Arm Shaft Tightening Sequence
10. Install rocker arm assemblies in correct order as removed. Tighten the rocker arm assemblies in sequence shown to 28 Nm (250 inch lbs.).
11. Install cylinder head cover and tighten fasteners to 12 Nm (105 inch lbs.).
12. Install ignition coil pack and ignition cables.
13. Perform camshaft and crankshaft timing relearn procedure as follows:
-
Connect the DRB scan tool to the data link (diagnostic) connector. This connector is located in the passenger compartment; at the lower edge
of instrument panel; near the steering column.
-
Turn the ignition switch on and access the "miscellaneous" screen.
-
Select "re-learn cam/crank" option and follow directions on DRB screen.
