Neon L4-2.0L VIN C (1997)
2. Install the 2 CAB bracket mounting nuts and securely tighten.
3. Install the 60-way wiring harness connector by hand into the 60-way CAB connector, as far as possible. Then use the CAB connector retaining
bolt to fully seat wiring harness connector into the CAB.
4. Torque the 60-way connector retaining bolt to 4 Nm (38 inch lbs.).
5. If a new CAB is being has been installed, it must be initialized prior to the vehicle being driven. The CAB is initialized using the DRB Scan Tool
and the initializing procedure described upon selecting Bendix ABX-4 Diagnostics. New controllers are programmed to flash the ABS warning
lamp until initialized by the installing technician.