Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Powertrain Management > Computers and Control Systems > Powertrain Control Module <--> [Engine Control Module] > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Powertrain Control Module: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 1429

Page 21
background image

FIGURE 4B - Mounting Fuel Resevoir/Filter

2.

Install supplied fuel reservoir/filter, PN 4418012, using two (2) self-tapping screws, PN 6022777 (Figure 4-B). Screws must be tightened to
95 +/- 10 inch pounds.

NOTE:

RUBBER SPLASH SHIELD MAY HAVE TO BE CUT OUT AROUND FUEL RESERVOIR.

3.

Remove and discard the fuel pump outlet tube, return hose, and fuel filter with rubber hoses and clamps. Install the fuel pump-to-reservoir
tube, PN 4306968 (Figure 4-B).

4.

Install return hose assembly, PN 4418006, from the fuel reservoir return nipple to the chassis tube, and clamp with PN 6500650 at each end
(Figure 4-B).

5.

Slide both 6" pieces of convolute sleeve, PN 4279993, over each 5/16" x 8" hose, PN 42O3576.

Powertrain Management > Computers and Control Systems > Powertrain Control Module <--> [Engine Control Module] > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Powertrain Control Module: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 1429

[PREV PAGE] [NEXT PAGE]