PB 150 V8-318 5.2L VIN T 2-BBL (1983)
HEADLAMP AND DASH WIRING ASSEMBLY
Disconnect the battery positive lead (single in-line connection) from the headlamp and dash wiring assembly (Figure 6-A).
FIGURE 6-B - TERMINAL END OF BULKHEAD CONNECTOR(ENGINE COMPARTMENT SIDE)
Remove the following wires from the engine compartment side of the bulkhead connector (Figure 6-B).
Red wire from cavity #39 (ammeter).
Black wire from cavity #33 (ammeter).
Cut off the terminals and wrap tape around each end of both wires to insure that shorting cannot occur. Then tape the wrapped wires back
against the main harness.