![]() |
Plymouth Workshop Manuals | |
PB 150 V8-318 5.2L VIN T 2-BBL (1983)Powertrain Management > Fuel Delivery and Air Induction > Carburetor > Carburetor Jet > Component Information > Technical Service Bulletins > High Altitude Conversion Packages![]() Technical Service Bulletin # 250383 Date: 830808 High Altitude Conversion Packages Models 1983 Light Duty Trucks With 2.2L, 225-1, 318-2 & 318- 4BBL Engines & Low Altitude Emission Systems Subject High Altitude Conversion Packages & Adjustment For Improved Engine Performance & Emissions Index EMISSIONS Date August 8, 1983 No. 25-03-83 P-2790-C A package is now available to accommodate a customer who wishes to convert his 1983 low altitude emission package to the high altitude (over 4,000 Vehicles with the low altitude package transferred to service in high altitude areas may exhibit undesirable driveability.. However, the installation of a The high altitude field conversion packages and procedures outlined below have been authorized on the following 1983 non-altitude equipped engine Conversion Instructions FIGURE 1 Sea Level to Altitude IMPORTANT: IN SOME OF THE CONVERSION PROCEDURES YOU WILL BE REQUIRED TO INSTALL A NEW VEHICLE EMISSION THIS LABEL HAS TWO AREAS THAT ARE IMPACT IMPRINTABLE WITH A TYPEWRITER (SEE FIGURE 1). If you are required to readjust timing, curb idle speed, or fast idle speed to a specification different than the original VECI label specification, then just Powertrain Management > Fuel Delivery and Air Induction > Carburetor > Carburetor Jet > Component Information > Technical Service Bulletins > High Altitude Conversion Packages | ||
[PREV PAGE] [NEXT PAGE] |