Plymouth Workshop Manuals
PB 150 V8-318 5.2L VIN T 2-BBL (1983)
Powertrain Management > Fuel Delivery and Air Induction > Fuel Reservoir > Component Information > Technical Service Bulletins > Customer Interest for Fuel Reservoir: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 2030
heated rear window defroster.
Reconnect battery. Start the engine, and inspect the entire system for fuel leaks and proper wire and hose routing.
Reinstall engine cover.
F.1981-1984 Models Equipped With Carter Thermoquad 4BBL Carburetor Only - Fuel Pressure
FIGURE 5FUEL PRESSURE REGULATOR INSTALLATION
Remove the original carburetor inlet fuel tube and fuel tube clip (attached to boss on intake manifold) and discard.
Fasten the bracket, PN 4418010, to the fuel pressure regulator, PN 4418009, using the two (2) self-tapping screws supplied, PN 6033066
BE SURE THAT OUTLET SIDE OF REGULATOR FACES THE CARBURETOR INLET.
At the tapped boss on the right side of the intake manifold, install bracket and fuel pressure regulator assembly using the screw and washer,
IF THERE EXISTS AN A/C ALTERNATOR BRACKET SUPPORT STRUT IN THIS LOCATION, THEN LOOSEN THE
BE EXTREMELY CAREFUL NOT TO DAMAGE OR PINCH ANY HARNESS IN THE AREA.
|[PREV PAGE] [NEXT PAGE]|