Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Fuel Gauge Sender: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 2083

Page 2
background image

Refer to parts list for contents of each package.

Must be ordered separately:

1

Authorized Modification Label

PN 4275086

NOTE:

IT IS IMPORTANT THAT THE SPECIFIED FUEL TANK SIZE
APPLICATION PACKAGE BE SELECTED. THE USE OF AN IMPROPER PART NUMBER PACKAGE MAY CAUSE THE
VEHICLE TO RUN OUT OF FUEL WELL BEFORE THE GAUGE READS EMPTY.

REPAIR PROCEDURE

A.Engine Compartment Harness Pn 4362295

1.

Disconnect the battery.

2.

Remove engine side of bulkhead connector. Depress fingers on instrument panel half of bulkhead connector, and push connector back
through the hole into the passenger compartment.

FIGURE 1A - ENGINE COMPARTMENT WIRING

3.

Remove engine cover. Install the bare eyelet terminal of overlay harness, PN 4362295, to the negative terminal of the ignition coil as shown
in Figure 1-A.

FIGURE 1B - ENGINE COMPARTMENT WIRING

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Fuel Gauge Sender: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 2083

[PREV PAGE] [NEXT PAGE]