Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Powertrain Management > Ignition System > Sensors and Switches - Ignition System > Crankshaft Position Sensor > Component Information > Service and Repair > RWD W/ Electronic Spark Control > Page 2286

Page 2
background image

Fig. 14 Typical disassembled view of Chrysler electronic 8 cylinder distributor (Dual pickup distributor similar)

4.

On eight cylinder units, if distributor housing, shaft, reluctor sleeve or governor weights are to be replace, proceed as follows:

a. Remove distributor shaft retaining pin and slide retainer off end of shaft.
b. If necessary, use a file to clean burrs from around pin hole area on shaft, then remove lower thrust washer.
c. Push shaft upward and remove from distributor housing.

Distributor Assembly

Powertrain Management > Ignition System > Sensors and Switches - Ignition System > Crankshaft Position Sensor > Component Information > Service and Repair > RWD W/ Electronic Spark Control > Page 2286

[PREV PAGE] [NEXT PAGE]