Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Component Information > Service and Repair

Page 1
background image

Ignition Switch: Service and Repair

Fig. 1 Lock cylinder removal. Less tilt steering wheel

MODELS LESS TILT STEERING

1.

Disconnect battery ground cable and remove turn signal switch as outlined in this chapter.

2.

Remove ignition key lamp assembly attaching screws, then the assembly.

3.

Remove snap ring from upper end of steering shaft.

4.

Remove bearing housing to lock housing attaching screws, then the bearing housing from the shaft.

5.

Remove buzzer switch attaching screws, then the buzzer switch, if equipped.

6.

Remove lock lever guide plate attaching screws, then the lock plate.

7.

Place lock cylinder in the "Lock" position and remove key. Using a suitable tool, depress spring loaded lock retainer and pull lock cylinder from
housing bore.

8.

Remove ignition switch attaching screws, then the ignition switch.

9.

Reverse procedure to install.

Fig. 2 Lock cylinder removal. W/tilt steering wheel

MODELS WITH TILT STEERING

Fig. 2 Lock cylinder removal. W/tilt steering wheel

Ignition Lock, Replace

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Component Information > Service and Repair

[PREV PAGE] [NEXT PAGE]