![]() |
Plymouth Workshop Manuals | |
PB 150 V8-318 5.2L VIN T 2-BBL (1983)Powertrain Management > Tune-up and Engine Performance Checks > Idle Speed > System Information > Technical Service Bulletins > All Technical Service Bulletins for Idle Speed: > 250383 > Aug > 83 > High Altitude Conversion Packages > Page 1246![]() pulley cover. Between the engine and the vacuum harness loop the hose approximately 2.5" from the vacuum reducer valve and connect to the 10. Tape the four nylon-vacuum tubes together at the edge of the in-line connector. FIGURE 2 See Figure 2 attached INSTALLATION OF A VACUUM REDUCER VALVE ON A 3.7L ENGINE VACUUM REDUCER INSTALLATION PACKAGE PN 4293798 PARTS REQUIRED PART NUMBER 1 - Vacuum Reducer Valve 4104184 1 - Tee 4241296 INSTALLATION PROCEDURE 1. Cut two 1.5" sections of 3/16" hose (use Bulk Stock PN 3780507) and install on the white nipples of the Vacuum Reducer Valve, PN 4114184. 2. Cut one 8" length of 3/16" hose and install on the remaining nipple of the vacuum reducer valve. Install the Tee, PN 4104172, at the other end on 3. Locate the orange striped hose connecting the vacuum amplifier in the vacuum solenoid. Cut this hose 2.5" from the solenoid and install the tee of 4. Locate the vacuum hose, harness bundle running along the inside of the valve cover. Cut the yellow striped hose midway between the two tape Powertrain Management > Tune-up and Engine Performance Checks > Idle Speed > System Information > Technical Service Bulletins > All Technical Service Bulletins for Idle Speed: > 250383 > Aug > 83 > High Altitude Conversion Packages > Page 1246 | ||
[PREV PAGE] [NEXT PAGE] |