Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Powertrain Control Module <--> [Engine Control Module] > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Powertrain Control Module: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 101

Page 26
background image

FIGURE 6-C - 78 AMP ALTERNATOR WIRING

3.

Remove the alternator output wire (heavy gauge) from the 60 amp alternator (Figure 6-C). Cut the wire off leaving approximately three (3)
inches of wire extending out of the main harness. Tape the end of the lead thoroughly. Then fold and tape the lead back against the main
harness to prevent shorting.

4.

Remove 60 amp alternator assembly and install 78 amp alternator assembly, PN 4111204, per the service manual alternator replacement
procedure.

HEADLAMP AND DASH WIRING ASSEMBLY

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Powertrain Control Module <--> [Engine Control Module] > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Powertrain Control Module: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 101

[PREV PAGE] [NEXT PAGE]