Plymouth Workshop Manuals
PB 150 V8-318 5.2L VIN T 2-BBL (1983)
Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Fuel Gauge Sender: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 257
FIGURE 5FUEL PRESSURE REGULATOR INSTALLATION
Install new tube, PN 4418008, from the regulator outlet to the carburetor inlet. Install new tube, PN 4418014, from the reservoir outlet hose
Install clamp, PN 6500651, as shown in Figure 5 (filter outlet hose-to-regulator inlet tube). Rotate clamp so that it is not in contact with any
For all models except those equipped with dual air conditioning units, without electrically heated rear window defroster and with 60 amp alternator:
Reconnect battery. Check wire and hose routing, start the engine, and inspect the entire system for fuel leaks.
Reinstall engine cover.
G.Vehicles Equipped With Dual Air Conditioning Units, Without Electrically Heated Rear Defroster,
|[PREV PAGE] [NEXT PAGE]|